Quality standards within EPA Manufacturing

TECHNICAL STANDARDS AND SUPPLEMENTARY DOCUMENTS. Unless otherwise stated, the following documents shall be applied when executing these Specifications: Sniper Extreme Standards and drawings - Various calibers and types.

 

BS6001-0:2006/ ISO-2859-10:2006 - Part 0 - Introduction to BS 6001 (ISO2858)series of standards for sampling for inspection by attributes.

 

BS6001-1:1999/ ISO-2859-1:1999 - Part 1 - Sampling schemes indexed by Acceptance Quality Limit (AQL) for lot by lot inspection.

 

ISO 3951-1:2013 - Sampling procedures for inspection by variables. Part 1: Specification for single sampling plans indexed by Acceptance Quality Limit (AQL) for lot by lot inspection for a single quality characteristic and a single AQL.

 

ANSI/ASQ Z1.4 - 2003 - Sampling plans and procedures for inspection by attributes.

 

MIL-STD-636 - Visual inspection standards of Small Arms Ammunition through to .50 caliber.

 

MIL-STD-1168A - Ammunition Lot Numbering.

 

MIL-A-48078 (AR) - Ammunition, Standard Quality Assurance Provisions.

 

CIP 2011 - Commission Internationale Permanente European standard for small arms ammunition.

 

NATO PFP (NAAG-LCG/1–SG/1)WP(2010)0002 - Multi Caliber MOPI (WHERE APPLICABLE).

 

ANSI/SAAMI Z-2299.4 - 1992 - Voluntary industry performance standards for pressure and velocity of Centerfire rifles and sporting ammunition for the use of commercial manufacturers.

 

 

1.1 - Order of Priority

 

It is recognised that different standards exist for different countries and clients, much of this will be accommodated in subsequent technical acceptance plans. For the purpose of this Technical Qualification Acceptance Plan, taking into account all the supplementary documents mentioned on the previous page, priority shall be given to the following standards;

 

Sniper Extreme Standards and drawings various calibers and types.

 

BS6001-0:2006/ ISO-2859-10:2006 - Part 0 - Introduction to BS 6001 (ISO2858)series of standards for sampling for inspection by attributes.

 

BS6001-1:1999/ ISO-2859-1:1999 - Part 1 - Sampling schemes indexed by acceptance quality limit (AQL) for lot by lot inspection.

 

ANSI/ASQ Z1.4 - 2003 - Sampling plans and procedures for inspection by attributes.

 

CIP  2011 - Commission Internationale Permanente. European standard for small arms ammunition.

 

ANSI/SAAMI Z-2299.4 – 1992 - Voluntary Industry Performance Standards For Pressure And Velocity Of Centerfire Rifles Sporting Ammunition For The Use Of Commercial Manufacturers.

 

NATO PFP(NAAG-LCG/1–SG/1)WP(2010)0002 - Multi Caliber MOPI (WHERE APPLICABLE).

 

MIL-STD-636 - For visual inspection of the cartridges.

 

MIL-STD-1168A - For the numbering of the lots.

 

Site Menu ¬

CONTACT EPA

ABOUT EPA